Dan, question about fret slot depth

When it comes to CAM I use the 2D trace and pick my fret slotting bit as the tool, and the lines to trace Then use a negative depth to get the

Dan, question about fret slot depth When it comes to CAM I use the 2D trace and pick my fret slotting bit as the tool, and the lines to trace Then use a negative depth to get the

When it comes to CAM I use the 2D trace and pick my fret slotting bit as the tool, and the lines to trace Then use a negative depth to get the

p168 slot Simply hold the flat edge against the fret tang, note the height of the tang against the reference lines, fit the appropriate curved edge into the slot, and

Ensure proper fit for fretwire with this depth gauge tool · Quickly check the depth and cleanliness of fret slots before installation · Developed by Dan Erlewine

fret slot depth Throughout this article I will be using a diameter endmill to cut the fret slots The width of this cutter determines the width of the slot

I tried wide Then program a 3D finish path cutting the same direction as the fret slot I had to play around with the stepover to get a