Fret Slotting Mitre Jig

The jig sits over the fretboard blank The fret cutting saw just fits in the slots and the acrylic being 6mm thick should hold the saw square I

Fret Slotting Mitre Jig The picture below shows a guitar neck, the fret slots can either be cut at a 3 mm depth following the radius of the fretboard or

The jig sits over the fretboard blank The fret cutting saw just fits in the slots and the acrylic being 6mm thick should hold the saw square I

list of slot games depth guide The perspex fret saw depth guid

It currently has the original vintage fretwire with tang depth around 060 I would like to install jumbo EVO 57110 fretwire but it has tang

fret slot width They are used for cutting the fret slots in fingerboards and for executing the clean-up pass when cutting inlay pockets The enhanced rigidity of the

pop one in a stewmac mini router base with a dremel or foredom, carefully set the depth and carefully run it through the fret slot and you'll